Skip to Content

Jovial Marine Products

  1. All products
  2. Watermakers
  3. Components
  4. Fittings BP
  5. Bulkhead fitting
  6. Fittings BP
Pricelist: DEFAUT - Site & devis Pricelist
Pricelist: DEFAUT - Site & devis Pricelist
Bulkhead fitting

Bulkhead fitting

Essential for passing through a bulkhead on your boat while keeping a fully watertight joint.
3.12 € 3.12 €
(Hors taxes)
( 3.12 €/Units)
  • Taille Tube 1
Contact Us
Material:How to use it:Precautions:

Material:

Black acetal resin (POM), elastomer O-rings (NBR or EPDM).

How to use it:

  1. Drill the bulkhead to the thread diameter: M16 for 6 mm tube, M20 for 10 mm, M27 for 12 mm.
  2. Pass the fitting through the hole, then tighten the nut to hold it against the bulkhead.
  3. Cut each tube square, clean and free of cracks, then push it fully into the fitting with moderate force.
  4. Pull lightly on the tube to check that it holds.
  5. To remove it, release the pressure first, push the collet towards the fitting body and pull the tube out.

Assembly diagram for a bulkhead fitting: wrong assembly (tube not fully inserted) and correct assembly (tube pushed fully home)

Precautions:

  • For water only, up to 65 °C (150 °F).
  • Do not strain the fitting by turning, twisting or bending it.